ChemBrite Ind.

16323 - 130 Avenue,  Edmonton,  Alberta,  Canada,  T5V 1K5    Tel / Fax: (780) 474 5298



        Strip-Brite 277 - Low Environmental Impact Paint Remover



To our best knowledge, the information and recommendations contained herein are accurate and reliable.  However, this information and our recommendations are furnished without warranty, expressed or implied.  The manufacturer’s sole obligation shall be to replace the portion of the product proven to be defective.  The seller or manufacturer shall not be liable for any loss, damage or injury from the use or possession of this product.

Strip-Brite 277 contains Benzyl Alcohol and Hydrogen Peroxide.   Avoid ingestion, inhalation of vapour, and contact with skin, eyes and clothing.  Use a face shield and solvent resistant clothing when handling or working with this product. Some surface materials may be incompatible with this stripper; test a small area to ensure proper results.

Strip-Brite 277 should be used full strength at 65 - 85 ˚ F.  Apply a thick and even coat with a non-atomizing spray or brush.  Allow sufficient time for paint to loosen (4 to 16 hours) and then agitate with a stiff bristle brush.  Check if paint has been completely removed; if not, apply an additional coat of Strip-Brite 277 and allow more time for stripping.  When stripping is complete, wash with cold or warm water at 50 psi or higher.

Strip-Brite 277 is an environmentally friendly paint remover formulated to remove tough coatings from most surfaces.  Strip-Brite 277 is pH neutral gel that clings to vertical surfaces and is extremely effective on multiple coats of paint.  It is non-flammable and  stable for at least 1 year.  Will not cause hydrogen embrittlement  to high strength steel as per MIL-R-81294 test.  Strip-Brite 277 is non-flammable and formulated with a superior detergent system to allow for easy rinsing.